< Day Day Up >

MPLS Configuration on Cisco IOS Software By Lancy Lobo, -  CCIE No. 4690, Umesh Lakshman ............................................... Publisher: Cisco Press Pub Date: October 21, 2005 ISBN: 1-58705-199-0 Pages: 720

Table of Contents  | Index

---

		Copyright
		About the Authors
			About the Technical Reviewers
		Acknowledgments
			This Book Is Safari Enabled
		Icons Used in This Book
		Command Syntax Conventions
		Foreword
		Introduction
			Who Should Read This Book?
			How This Book Is Organized
		Chapter 1.  MPLS Overview
			Unicast IP Forwarding in Traditional IP Networks
			Overview of MPLS Forwarding
			MPLS Terminology
			MPLS Control and Data Plane Components
			MPLS Operation
			Special Outgoing Label Types
			Penultimate Hop Popping
			Frame-Mode MPLS
			Cell-Mode MPLS
		Chapter 2.  Basic MPLS Configuration
			Frame-Mode MPLS Configuration and Verification
			Cell-Mode MPLS over ATM Overview, Configuration, and Verification
			Command Reference
		Chapter 3.  Basic MPLS VPN Overview and Configuration
			VPN Categories
			MPLS VPN Architecture and Terminology
			MPLS VPN Routing Model
			MPLS VPN Basic Configuration
			Outbound Route Filters
			Command Reference
		Chapter 4.  PE-CE Routing Protocol—Static and RIP
			Static PE-CE Routing Overview, Configuration, and Verification
			Static PE-CE Routing Command Reference
			RIPv2 PE-CE Routing Overview, Configuration, and Verification
			RIPv1 PE-CE Routing Configuration and Verification
			RIP PE-CE Routing Command Reference
		Chapter 5.  PE-CE Routing Protocol—OSPF and EIGRP
			OSPF PE-CE Routing Protocol Overview, Configuration and Verification
			EIGRP PE-CE Routing Protocol Overview, Configuration, and Verification
		Chapter 6.  Implementing BGP in MPLS VPNs
			BGP PE-CE Routing Protocol Overview, Configuration, and Verification
			Implementing Route-Reflectors in MPLS VPN Networks
			Case Study—Hub and Spoke MPLS VPN Network Using BGP PE-CE Routing for Sites Using Unique AS Numbers
			Case Study—Hub and Spoke MPLS VPN Network with Sites Using Same AS Numbers
			Command Reference
		Chapter 7.  Inter-Provider VPNs
			Overview of Inter-Provider VPNs
			Option 1: Inter-Provider VPN Using Back-to-Back VRF Method
			Option 2: Inter-Provider VPNs Using ASBR-to-ASBR Approach
			Option 3: Multi-Hop MP-eBGP Between RR and eBGP Between ASBRs
			Option 4: Non-VPN Transit Provider
			Case Study—Inter-AS Implementing Route-Reflector and BGP Confederation in Provider Networks
			Case Study—Multi-Homed Inter-AS Provider Network
			Command Reference
		Chapter 8.  Carrier Supporting Carriers
			Carrier Supporting Carriers Overview
			Deployment Scenarios with CSC Architecture
			CSC Architecture Benefits
			Command Reference
		Chapter 9.  MPLS Traffic Engineering
			TE Basics
			MPLS TE Theory
			Constraint-Based Routing and Operation in MPLS TE
			Configuring MPLS TE
			Command Reference
		Chapter 10.  Implementing VPNs with Layer 2 Tunneling Protocol Version 3
			L2TPv3 Overview
			Configuring L2TPv3 Tunnels for Layer 2 VPN
			Configuring L2TPv3 Static Tunnels
			Configuring L2TPv3 Dynamic Tunnels
			Implementing Layer 3 VPNs over L2TPv3 Tunnels
			Command Reference
		Chapter 11.  Any Transport over MPLS (AToM)
			Introduction to Layer 2 VPNs
			Implementing AToM for Like to Like Circuits
			L2 VPN—Any to Any Interworking
			Local Switching
			Command Reference
		Chapter 12.  Virtual Private LAN Service (VPLS)
			VPLS Overview
			VPLS Topology—Single PE or Direct Attachment
			Hierarchical VPLS—Distributed PE Architecture
			Command Reference
		Chapter 13.  Implementing Quality of Service in MPLS Networks
			Introduction to QoS—Classification and Marking
			MPLS QoS Implementation
			MPLS QoS Operating Modes
			Modular QoS CLI: Configuration of QoS on Cisco Routers
			Configuration and Implementation of MPLS QoS in Uniform Mode and Short Pipe Mode Operation
			Implementing MPLS QoS for Layer 2 VPN Implementations
			Command Reference
		Chapter 14.  MPLS Features and Case Studies
			Case Study 1: Implementing Multicast Support for MPLS VPNs
			Case Study 2: Implementing Multi-VRF CE, VRF Selection Using Source IP Address, VRF Selection Using Policy-Based Routing, NAT and HSRP Support in MPLS VPN, and Multicast VPN Support over Multi-VRF CE
			Case Study 3: Implementing Layer 2 VPNs over Inter-AS Topologies Using Layer 2 VPN Pseudo-Wire Switching
			Case Study 4: Implementing Layer 3 VPNs over Layer 2 VPN Topologies and Providing L2 VPN Redundancy
			Case Study 5: Implementing Dynamic Layer 3 VPNs Using mGRE Tunnels
			Case Study 6: Implementing Class-Based Tunnel Selection with MPLS Traffic Engineering
			Case Study 7: Implementing Hub and Spoke Topologies with OSPF
			Case Study 8: Implementing Hub and Spoke Topologies with EIGRP
			Case Study 9: Implementing VPLS Services with the GSR 12000 Series
			Case Study 10: BGP Site of Origin
			Command Reference
		Index

< Day Day Up >

Arnold, Salina and Arnold, Shanda